ServerNet Cluster 6780 Operations Guide (G06.28+, H06.05+)

SCF Commands for SNETMON and the ServerNet
Cluster Subsystem
ServerNet Cluster 6780 Operations Guide—525606-003
4-5
ALTER SUBSYS Command
To set the STARTSTATE attribute, use the ALTER SUBSYS command. (See the
ALTER SUBSYS Command on page 4-5.)
ALTER SUBSYS Command
The ALTER SUBSYS command modifies the value of the STARTSTATE and
STATSEVENT attributes for the ServerNet cluster subsystem. You can issue the
ALTER SUBSYS command without stopping the ServerNet cluster subsystem. ALTER
SUBSYS is a sensitive command.
The ALTER SUBSYS command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
attribute-spec
specifies the attributes to be modified and the corresponding values to be
assigned. It is one of these attribute name and value combinations:
STARTSTATE [ STARTED | STOPPED ]
The STARTSTATE attribute specifies the start state of the ServerNet cluster
subsystem when the system is loaded.
STARTED
specifies that the ServerNet cluster subsystem automatically moves into
the STARTED logical state when the system is loaded and joins the system
to the ServerNet cluster.
STOPPED
The ServerNet cluster subsystem must be manually moved into the logical
STARTED state using the SCF START SUBSYS command.
If STARTSTATE
is set to . . . Then
STARTED The ServerNet cluster subsystem automatically moves into the
STARTED logical state and joins the system to the ServerNet cluster.
STOPPED The ServerNet cluster subsystem waits for a START SUBSYS
command before moving into the STARTED logical state and joining
the system to the ServerNet cluster.
ALTER [ / OUT file-spec / ] SUBSYS $ZZSCL {, attribute-spec }