ServerNet Cluster 6780 Operations Guide (G06.29+, H06.06+, J06.03+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-004
5-6
Considerations
BLINK { ALL | FAULTLEDS | NONE }
causes LEDs on the specified switch to blink as follows:
For the location of the LEDs on the 6780 switch, see Figure 3-8 on page 3-27.
LOCATOR string
is an identifier string of ASCII characters that can be used to describe or help
locate the cluster switch. For 6770 switches, the string is limited to 32
characters. For 6780 switches, the string is limited to 64 characters.
FABRICSETTING
specifies the fabric LED setting for 6770 switches. Must be one of: X, Y, or
NONE.Not valid for 6780 switches.
Considerations
•
The ALTER command is a sensitive command and can be used only by a super-
group user (255, n) ID.
•
Wild cards are not supported for the ALTER SWITCH command.
•
Only one attribute specification (LOCATOR, BLINK, or FABRICSETTING) can be
specified in a single ALTER SWITCH command.
ALTER SWITCH Command Examples
This example sets the locator string for the cluster switch in zone 2, layer 3 of the
external Servernet Y fabric to a new value:
> ALTER SWITCH $ZZSMN, FABRIC Y, ZONE 2, LAYER 3, LOCATOR
"Building 3, Room 1346"
If the command is successful, SCF displays:
The ServerNet switch locator string has been altered.
ALL For 6770 switches, causes all switch port LEDs to blink.
For 6780 switches, causes the fault LEDs on all CRUs to
blink.
FAULTLEDS Causes the fault LEDs for all CRUs on the 6780 switch to
blink. FAULTLEDS is synonymous with ALL, but can only be
used with a 6780 switch.
NONE Stops all LEDs from blinking and restores the normal operat-
ing state of the LED.