ServerNet Cluster 6780 Operations Guide (G06.29+, H06.06+, J06.03+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-004
5-21
LOAD SWITCH Command
LOAD SWITCH Command
The LOAD SWITCH command is a sensitive command. It allows you to download a
configuration, firmware, or field-programmable gate array (FPGA) file from the server
to the cluster switch.
The LOAD command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
FABRIC { X | Y } | NEAREST { X | Y }
specifies the external ServerNet fabric of the local cluster switch you want to load.
NEAREST and FABRIC are synonymous in this case, and either can be used.
The local switch is the one directly connected to the node where you issue this
command.
FABRIC { X | Y } , ZONE znum , LAYER lnum
is a string of identifiers used to specify the cluster switch you want to load. Used
only in a ServerNet cluster built with 6780 switches.
FABRIC { X | Y } specifies the external ServerNet fabric.
ZONE znum specifies the cluster switch zone. znum must be in the range 1
through 3.
LAYER lnum specifies the cluster switch layer. lnum must be in the range 1
through 4.
CONFIG file
specifies the name of the configuration file to be downloaded. The file name should
be specified in the standard file system external format. The file must be located on
the local system. This form is valid only for 6780 switches in a layered topology.
Note. The LOAD command is intended for service providers only. To load firmware, configura-
tion, or FPGA for a cluster switch, use the OSM Service Connection.
LOAD [ / OUT file-spec / ] SWITCH $ZZSMN
{ , FABRIC { X | Y } | , NEAREST { X | Y } }
{ , FABRIC { X | Y } , ZONE znum , LAYER lnum }
{ , CONFIG file }
{ , CONFIG file, POSITION id, TOPOLOGY topo-id }
{ , FIRMWARE file }
{ , FPGA file }