ServerNet Cluster 6780 Operations Guide (G06.29+, H06.06+, J06.03+)

SCF Error Messages
ServerNet Cluster 6780 Operations Guide—525606-004
6-13
SANMAN (SMN) Error Messages
SMN Error 00038
Cause. The command specified a FABRICSETTING attribute, but the specified switch
does not support the FABRICSETTING attribute.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct and reissue the command.
SMN Error 00039
Cause. The command specified an FPGA file, but the switch specified does not
support loading an FPGA file.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct and reissue the command.
SMN Error 00040
Cause. The command did not specify a file to download or it specified more than one
file.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct and reissue the command.
SMN Error 00041
Cause. The command was issued with either no switch specifier or an incorrect
switch specifier.
Cause. The command is not executed. SCF waits for the next command.
Recovery. Correct and reissue the command. The FABRIC, ZONE, LAYER
specification can be used only for switches in a layered topology.
SMN E00038 FABRICSETTING attribute is not allowed for the
specified switch.
SMN E00039 An FPGA file can not be downloaded to the
specified switch.
SMN E00040 No file to download was specified or more than one
was specified.
SMN E00041 Switch not specified or switch incorrectly
specified.