ServerNet Cluster 6780 Operations Guide (G06.29+, H06.06+, J06.03+)

SCF Commands for SNETMON and the ServerNet
Cluster Subsystem
ServerNet Cluster 6780 Operations Guide—525606-004
4-9
PRIMARY Command
Stats event
shows the current value of the STATSEVENT attribute for the ServerNet cluster
subsystem. Possible values are:
PRIMARY Command
The PRIMARY PROCESS command is a sensitive command. It causes a processor
switch, where the backup processor becomes the primary processor and the primary
processor becomes the backup processor.
The PRIMARY command syntax for the ServerNet cluster monitor process is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
processor
is the processor number of the current backup processor for the ServerNet cluster
monitor process.
Consideration
Wild cards are not supported for the PRIMARY PROCESS command.
ON The ServerNet cluster subsystem is configured so that statistics
events are generated by each local processor for every node in
the cluster known to the local node, including the local node
itself. This value is the default.
OFF The ServerNet cluster subsystem is configured so that
processors do not generate statistics events.
LOCALONLY The ServerNet cluster subsystem is configured so that statistics
events are generated by each local processor for the local node
only.
n/a This value indicates that the SNETMON process does not
support configuration of statistics events generation. In this case,
statistical events are generated as if the STATSEVENT attribute
is set to ON.
PRIMARY [ / OUT file-spec / ] PROCESS $ZZSCL [, processor ]