ServerNet Cluster 6780 Planning and Installation Guide (G06.24+, H06.03+)

Checking Operations
ServerNet Cluster 6780 Planning and Installation Guide—527301-004
8-13
Checking MSGMON, SANMAN, and SNETMON
Checking MSGMON, SANMAN, and SNETMON
Perform this procedure:
•
Before adding a node to a ServerNet cluster
•
If you cannot start the ServerNet cluster subsystem
•
If you cannot connect to a remote node
•
If you cannot display information about the ServerNet cluster in the OSM Service
Connection
To avoid conflicts with OSM and the guided procedures, you must configure
$ZZKRN.#MSGMON, $ZZKRN.#ZZSMN, and $ZZKRN.#ZZSCL to be the symbolic
names for MSGMON, SANMAN, and SNETMON.
Use the SCF interface to the Kernel subsystem to check that these processes are
configured correctly and in the STARTED state:
1. Display a list of all currently configured generic processes:
-> INFO PROCESS $ZZKRN.*
2. Check that the MSGMON, SANMAN, and SNETMON processes are displayed in
the *Name column with these required SCF symbolic names:
3. If not configured using these names, configure each process as described in
Appendix E, Configuring MSGMON, SANMAN, and SNETMON.
4. Check that MSGMON, SANMAN, and SNETMON are configured correctly. For
example:
-> INFO PROCESS $ZZKRN.#MSGMON, DETAIL
-> INFO PROCESS $ZZKRN.#ZZSMN, DETAIL
-> INFO PROCESS $ZZKRN.#ZZSCL, DETAIL
Compare the configured modifiers for MSGMON, SANMAN, and SNETMON with
the recommended modifiers shown in Appendix E, Configuring MSGMON,
SANMAN, and SNETMON.
Process TACL Name
Required SCF
Symbolic Name
SANMAN $ZZSMN $ZZKRN.#ZZSMN
SNETMON $ZZSCL $ZZKRN.#ZZSCL
MSGMON $ZIMnn $ZZKRN.#MSGMON