ServerNet Cluster 6780 Planning and Installation Guide (G06.24+, H06.03+)

Troubleshooting
ServerNet Cluster 6780 Planning and Installation Guide—527301-004
10-10
Fallback Procedures
Fallback Procedures
Before falling back to software that does not meet the minimum requirements
(Hardware Installation and Migration Planning on page 3-5) for the layered topology
and the 6780 switches, remove the node from the ServerNet cluster. Refer to
Removing a Node From a ServerNet Cluster on page 9-3.
Fallback to a Previous RVU
This procedure requires a system load.
1. For instructions on fallback to a previous RVU, refer to:
•
G06.nn Software Installation and Upgrade Guide
•
NonStop System Console Installer Guide
•
Interactive Upgrade Guide 2
2. Refer to Checking for Problems Between Nodes on page 8-4.
Fallback to Previous SPRs
This procedure does not require a system load:
1. For instructions on fallback to previous SPRs, refer to:
•
DSM/SCM User Manual
•
Softdocs for each of the SPRs
2. Refer to Checking for Problems Between Nodes on page 8-4.
Note. Fallback to previous versions of the 6780 switch firmware, configuration, and FPGA is
not necessary.