ServerNet Cluster 6780 Planning and Installation Guide (G06.24+, H06.03+)

Using the Long-Distance Option
ServerNet Cluster 6780 Planning and Installation Guide—527301-004
G-5
Hardware Installation
Setting the Numeric Selectors
Follow the guidelines in Task 3: Set the Numeric Selector on page 5-4, but do not use
the numeric selector settings described there.
Instead, set the numeric selectors for the switches to the values shown in Table G-2.
These settings are reserved for long-distance configurations and can be used only if all
the required software components in Table G-1 are installed.
Note. You must set the numeric selectors on all switches in the cluster to the values shown in
Ta ble G -2 so that all switches are recognized.
Table G-2. Numeric Selector Settings for the Long-Distance Option
6780
Switch Fabric Zone Layer
Numeric
Selector
X11 X 1 1 1411
X12 X 1 2 1412
X13 X 1 3 1413
X14 X 1 4 1414
X21 X 2 1 1421
X22 X 2 2 1422
X23 X 2 3 1423
X24 X 2 4 1424
Y11 Y 1 1 1511
Y12 Y 1 2 1512
Y13 Y 1 3 1513
Y14 Y 1 4 1514
Y21 Y 2 1 1521
Y22 Y 2 2 1522
Y23 Y 2 3 1523
Y24 Y 2 4 1524