ServerNet Cluster 6780 Planning and Installation Guide (G06.24+, H06.03+)

ServerNet Cluster Overview
ServerNet Cluster 6780 Planning and Installation Guide—527301-004
1-9
Expand Profiles Required
Expand Profiles Required
For each line type that you are using, these minimum product version updates (PVUs)
for the Expand profiles listed in Table 1-4 are required. These profiles are not standard
products on the site update tape (SUT) but are delivered on the SUT if ordered. If the
PVU was not included on the SUT or is not already installed on your NonStop S-series
server, you must install SPRs for these products.
ServerNet
Management Driver
T2800G08 A system generation and a system
load is required to install this SPR.
SP firmware T1089ABN A system generation and a system
load is required to install this SPR.
Logic board firmware T2789AAB For information about updating the
6780 switch logic board, refer to
Appendix F, Updating the 6780 Switch
Logic Board Firmware, Configuration,
and FPGA Images.
Logic board
configuration
T2790AAB
Logic board FPGA T2819AAB
Table 1-4. Expand Profiles Required
Expand Profile Product Version Update (PVU) Comments
ServerNet profile T0509AAD or later For every node in a ServerNet
cluster, the Expand/ServerNet
Profile is required.
SWAN group profile
for compatibility with
these line types:
•
X.25
•
NETDIRECT
•
NETSATELLITE
T0532AAD or later To create a ServerNet cluster
that operates with other
Expand line types, you must
order individual profile
products for the line types you
are using.
FastPipe profile for
compatibility with
these line types:
•
IP
•
ATM
•
FOX
T0533AAE or later For example, if you currently
are using Expand-over-IP lines
and you want to add Expand-
over-ServerNet lines and be
able to use both lines together,
you must buy the
Expand/FastPipe profile for
every node that needs an
Expand-over-IP line.
Table 1-3. Software Requirements for NonStop S-Series Servers (page 2 of 2)
RVU SPRs Required Comments