ServerNet Cluster 6780 Planning and Installation Guide (G06.29+, H06.06+, J06.03+)

ServerNet Cluster Hardware Description
ServerNet Cluster 6780 Planning and Installation Guide—527301-008
2-6
Identifying Components in a 6780 Switch
The 13 slots in the rear of each 6780 switch contain PICs as shown in Figure 2-2.
6780 Switch Plug-In Cards (PIC)
The PICs share the common midplane interface and provide the physical interface for
each ServerNet link. For ServerNet clusters, the PICs in the 6780 switch provide a
variety of connections as described in Table 2-4, 6780 Switch PICs, on page 2-6 . For
information about PIC LEDs, refer to Firmware, Configuration, and FPGA Images on
page 2-16.
Single-mode fiber (SMF) can be used for high-speed long-distance signal
transmission. It provides greater bandwidth than multimode. Multimode fiber (MMF) is
optical fiber designed to carry multiple light rays or modes concurrently, each at a
slightly different reflection angle within the optical fiber core. Because the modes tend
to disperse over longer lengths, multimode fiber transmission is used for relatively
short distances.
Figure 2-2. Plug-In Cards
Table 2-4. 6780 Switch PICs (page 1 of 2)
PIC Type Function PIC Slot Number of PICs for Each Switch
Maintenance Connections to the
ports on this PIC are
not supported.
Slot 1 1
Dual SMF or
Quad MMF
Zone Interconnect Slots 2
and 3
2 for ServerNet clusters with two or
three zones
Dual SMF Node Interconnect
between a NonStop
S-series server and a
6780 switch
Slots 6
through 9
Up to 4 depending on the number of
NonStop S-series servers connected
to the 6780 switch
Plug-in Cards (PICs)
13
1234567
8 9 101112
PIC Slots
VST600.vsd