ServerNet Cluster Manual

Installing and Configuring a ServerNet Cluster
ServerNet Cluster Manual—520575-003
3-8
Task 6: Add MSGMON, SANMAN, and SNETMON
to the System-Configuration Database
4. Check that MSGMON ($ZIMnn), SANMAN ($ZZSMN), and SNETMON ($ZZSCL)
are started:
-> STATUS PROCESS $ZZKRN.*
Configuring MSGMON, SANMAN, and SNETMON
You can configure MSGMON, SANMAN, and SNETMON by using a HP-supplied
macro or typing the SCF commands manually. Use one of the following procedures:
•
Adding MSGMON, SANMAN, and SNETMON Using the ZPMCONF Macro on
page 3-8
•
Adding MSGMON, SANMAN, and SNETMON Using SCF Commands on page 3-9
Adding MSGMON, SANMAN, and SNETMON Using the ZPMCONF Macro
The ZPMCONF macro automates the process of adding MSGMON, SANMAN, and
SNETMON to the system-configuration database. For a description of the macro, refer
to Appendix E, TACL Macro for Configuring MSGMON, SANMAN, and SNETMON.
To obtain the ZPMCONF macro, do one of the following:
•
If TSM Version 2000A or later is installed on the system console you are using, you
can obtain the macro from a web page stored on the workstation:
1. Click Start>Programs>Compaq TSM>Compaq S-Series Service (CSSI)
Web.
2. Click the NonStop™ ServerNet Cluster link.
3. Click Tools.
4. Click ZPMCONF.
5. Follow the instructions to download the macro.
If MSGMON, SANMAN,
and SNETMON are . . . Then . . .
Started Go to Task 7: Verify That $ZEXP and $NCP Are Started
on page 3-11.
Not started Start each process as described in Starting MSGMON,
SANMAN, and SNETMON on page 3-11.
Note. The ZPMCONF macro leaves the ServerNet cluster subsystem (also known as
ServerNet cluster services) in the STOPPED state. If you use a guided procedure to
configure and start Expand-over-ServerNet line-handler processes, the guided procedure
starts the subsystem for you. However, if you use another method for configuring line-
handler processes, you must start the subsystem manually using the SCF START
SUBSYS $ZZSCL command.