ServerNet Cluster Manual

Installing and Configuring a ServerNet Cluster
ServerNet Cluster Manual—520575-003
3-14
Task 8: Install the Cluster Switches
Required SPRs
If T0569AAB, T0569AAE (or a superseding SPR) will be loaded on the cluster switch,
you must check the software revision levels on each node to be connected to the
cluster switch. Table 3-5 lists the minimum SPR levels needed to support the
T0569AAB and T0569AAE (or a superseding SPR)
firmware and configuration.
Table 3-4. Firmware and Configuration Compatibility With the NonStop Kernel
If . . . Then all nodes must be running . . .
The ServerNet II Switch will have its
firmware and configuration updated with
T0569AAB.
•
G06.12 or a later RVU, or
•
G06.09, G06.10, or G06.11 and have the
required Release 2 SPRs listed in
Table 3-5 on page 3-15
The ServerNet II Switch will have its
firmware updated with T0569AAE (or a
superseding SPR) and its configuration
updated with one of the split-star
configuration tags from T0569AAE (or a
superseding SPR):
•
Max 16 nodes, nodes 1-8 (0x10000)
•
Max 16 nodes, nodes 9-16 (0x10001)
•
G06.14 or a later RVU, or
•
A pre-G06.14 RVU and have the required
Release 3 SPRs listed in Table 3-5
on
page 3-15
The ServerNet II Switch will have its
firmware updated with T0569AAE (or a
superseding SPR), and its configuration
updated with one of the tri-star
configuration tags from T0569AAE (or a
superseding SPR):
•
Max 24 nodes, nodes 1-8 (0x10002)
•
Max 24 nodes, nodes 9-16 (0x10003)
•
Max 24 nodes, nodes 17-24 (0x10004)
•
G06.14 or a later RVU, or
•
G06.13 and have the required Release 3
SPRs listed in Table 3-5 on page 3-15
Note. To check the current SPR levels, see Table 2-9
on page 2-24. To check the running
versions of cluster switch firmware and configuration, see Checking the Revisions of the
Running Firmware and Configuration on page 4-11.