ServerNet Cluster Manual

Managing a ServerNet Cluster
ServerNet Cluster Manual—520575-003
5-20
Monitoring Expand-Over-ServerNet Line-Handler
Processes
Monitoring Expand-Over-ServerNet Line-Handler Processes
You can use the WAN subsystem SCF STATUS DEVICE command to obtain
information about the state of a line-handler process. Example 5-8 shows a line-
handler process in the STARTED state.
Example 5-9 shows a line-handler process in the STOPPED state.
Monitoring Expand-Over-ServerNet Lines and Paths
You can use the following tools to obtain detailed information about Expand-over-
ServerNet lines and paths:
•
TSM Service Application
•
Guided procedure for configuring a ServerNet node
•
Expand subsystem SCF commands:
•
STATUS LINE, DETAIL Command on page 5-22
•
STATUS PATH, DETAIL Command on page 5-23
•
STATS LINE Command on page 5-23
•
STATS PATH Command on page 5-24
•
INFO LINE, DETAIL Command on page 5-24
•
INFO PATH, DETAIL Command on page 5-25
•
INFO PROCESS $NCP, LINESET Command on page 5-25
•
INFO PROCESS $NCP, NETMAP Command on page 5-26
For more information about using SCF commands for the Expand subsystem, refer to
the Expand Configuration and Management Manual.
Example 5-8. STATUS DEVICE Command Showing STARTED Line-Handler
Process
> STATUS DEVICE $ZZWAN.#SC001
WAN Manager STATUS DEVICE for DEVICE \BUZZ.$ZZWAN.#SC001
State : ........... STARTED
LDEV number ....... 97
PPIN................ 0 ,19 BPIN............. 1 ,15
Example 5-9. STATUS DEVICE Command Showing STOPPED Line-Handler
Process
> STATUS DEVICE $ZZWAN.#SC003
WAN Manager STATUS DEVICE for DEVICE \BUZZ.$ZZWAN.#SC003
State : ........... STOPPED