ServerNet Cluster Manual

Troubleshooting and Replacement Procedures
ServerNet Cluster Manual—520575-003
7-16
Using TSM Alarms
•
Ground Failure
•
Hardware Error
•
IBC Driver Limit for ServerNet Switches exceeded
•
Insufficient Backup Time on UPS
•
Invalid Fabric Parameter Error
•
Invalid Fabric Setting
•
Invalid FLASH ID
•
Invalid GUID
•
Invalid MSEB Confguration Record
•
Invalid ServerNet Switch Control Block
•
Invalid ServerNet Switch PIC Type
•
Link Receive Disabled on ServerNet Switch Port
•
Link Transmit Disabled on ServerNet Switch Port
•
Local ServerNet Switch Port not Connected to Remote ServerNet Switch Port
•
Low Battery Voltage
•
Low Inverter Voltage
•
Lower Boot Block Section of FLASH Locked
•
Missing Modular ServerNet Expansion Board
•
Missing NNA Plug-in Card
•
Missing Remote ServerNet Switch
•
Missing ServerNet Switch
•
Missing ServerNet Switch PIC
•
MSEB Confguration Record Fetch Error
•
New Configuration Incorrect After Load
•
NNA Verify Failure
•
Node Plugged Into Wrong Port of ServerNet Switch
•
Overloaded Switch AC Subsystem
•
Overloaded UPS
•
Packet Receive Disabled on ServerNet Switch Port
•
Packet Transmit Disabled on ServerNet Switch Port
•
Port Number Mismatch Between Local ServerNet Switch and Remote ServerNet
Switch
•
Power Supply Fan Failure
•
Primary Power Rail Failure
•
Program Checksum Error
•
Remote ServerNet Switch Connected to Wrong Port of Local ServerNet Switch
•
SANMAN Running Without a Backup
•
SEEPROM Checksum Error
•
ServerNet Services Initialization Error
•
ServerNet Switch Internal Stack Overflow
•
ServerNet Switch Not Responding
•
ServerNet Switch Operating on Battery Power
•
ServerNet Switch Port Disabled for ServerNet Traffic
•
ServerNet Switch Router Self-Check Error
•
Service Processor I/O Library Routine Call Error
•
SNETMON Running Without a Backup
•
SNETMON Unable to Discover Remote Node