ServerNet Cluster Manual

Troubleshooting and Replacement Procedures
ServerNet Cluster Manual—520575-003
7-22
Troubleshooting Expand-Over-ServerNet Line-
Handler Processes and Lines
5. If the Expand-over-ServerNet lines are stopped, start them by doing one of the
following:
•
Use the guided procedure for configuring a ServerNet node. For more
information, see Section 3, Installing and Configuring a ServerNet Cluster.
•
At an SCF prompt, type:
-> START LINE $SC004
6. Use the INFO PROCESS $NCP, NETMAP command to gain additional information
about the lines:
-> INFO PROCESS $NCP, NETMAP
7. If you continue to have problems, refer to the Expand Network Management and
Troubleshooting Guide.
Figure 7-7. Remote Node Attributes Showing Expand Information
VST045.vsd