ServerNet Cluster Manual

SCF Commands for SNETMON and the ServerNet
Cluster Subsystem
ServerNet Cluster Manual—520575-003
8-6
Example
•
If the ALTER SUBSYS command is entered correctly, an EMS message reports
the command, the time it was executed, the terminal from which the command was
entered, and the group and user numbers of the user issuing the command.
Example
The following command alters the STARTSTATE attribute for the ServerNet cluster
subsystem. The next time the system is loaded, the ServerNet cluster subsystem must
wait for a START SUBSYS command before moving into the STARTED state and
joining the system to the ServerNet cluster:
> ALTER SUBSYS $ZZSCL, STARTSTATE STOPPED
INFO Command
The INFO command returns the current values for the ServerNet cluster monitor
process configuration. INFO is a nonsensitive command.
The INFO command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
DETAIL
INFO SUBSYS and INFO SUBSYS, DETAIL show the same information.
Example
The following command displays the current configuration for the ServerNet cluster
monitor process:
> INFO SUBSYS $ZZSCL
Servernet Cluster - Info SUBSYS \SYS.$ZZSCL
StartState....... STARTED
CommandState..... STARTED
CommandTime....... 06 Jul 2000, 16:20:50.703
INFO [ /OUT file-spec/ ] SUBSYS $ZZSCL [ , DETAIL ]