ServerNet Cluster Manual

SCF Commands for SNETMON and the ServerNet
Cluster Subsystem
ServerNet Cluster Manual—520575-003
8-7
PRIMARY Command
The fields returned by the INFO SUBSYS command are as follows:
StartState
shows the current value of the STARTSTATE attribute for the ServerNet cluster
subsystem. Possible values are:
CommandState
shows the state for the ServerNet cluster subsystem that was last set by operator
command (including the implied operator command after system load), since the
last system load. Possible values are:
CommandTime
shows the time that the state of the ServerNet cluster subsystem was last set by
operator command (including the implied operator command after system load),
since the last system load (when the last START or STOP SUBSYS command was
entered).
PRIMARY Command
The PRIMARY command causes a processor switch. The backup processor becomes
the primary processor, and the primary processor becomes the backup processor.
PRIMARY is a sensitive command.
The PRIMARY command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
STARTED The ServerNet cluster subsystem is configured to move into the
STARTED state automatically and join the system to the
ServerNet cluster after a system load.
STOPPED The ServerNet cluster subsystem is configured to wait for a
START SUBSYS command before moving into the STARTED
state and joining the system to the ServerNet cluster.
STARTED The ServerNet cluster subsystem automatically performs join
processing in the event of a restart. If the ServerNet cluster is
already in a joined state, it remains joined with no disruption.
STOPPED The ServerNet cluster subsystem automatically performs
disconnect processing in the event of a restart. This ensures that
the system is properly disconnected from the ServerNet cluster.
PRIMARY [ /OUT file-spec/ ]PROCESS $ZZSCL [, cpunum ]