ServerNet Cluster Manual

ServerNet Cluster Manual—520575-002
9-1
9
SCF Commands for the External
ServerNet SAN Manager Subsystem
This section describes the SCF commands that are supported specifically for the
external ServerNet system area network (SAN) manager subsystem (SMN). The SMN
subsystem is used to manage the external ServerNet SAN manager process
(SANMAN).
Table 9-1 lists the SCF commands for the SMN subsystem.
To use all the features in this section, you must be running G06.16 or a later G-series
RVU, or you must have installed the SANMAN T0502AAH SPR. To determine the
features that were introduced at each RVU, see Table 9-2, SCF Features for SANMAN
by RVU.
Note. Commands that are generally supported by SCF, such as the ASSUME and ENV com-
mands, are documented in the SCF Reference Manual for G-Series RVUs.
Kernel subsystem SCF commands such as ADD, START and ABORT for configuring generic
(system managed) processes (such as the ServerNet SAN manager process, represented as a
PROCESS object) are documented in the SCF Reference Manual for the Kernel Subsystem.
Note. For SCF changes made at G06.21 to the SNETMON and SANMAN product modules
that might affect management of a cluster with one of the star topologies, see
Appendix I,
SCF Changes at G06.21.
Table 9-1. External ServerNet SAN Manager (SMN) Subsystem SCF Commands
Command
CONN
Object
PROCESS
Object
SWITCH
Object
Sensitive
Command? See page
ALTER Command
XYes9-3
INFO Command XXNo9-5
LOAD Command XYes9-13
PRIMARY Command XYes9-16
RESET Command XYes9-16
STATUS Command XXNo9-18
TRACE Command XYes9-34
VERSION Command XNo9-36