ServerNet Cluster Manual

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster Manual—520575-002
9-13
LOAD Command
UPS Info Valid
indicates whether the uninterruptible power supply (UPS) information is valid.
Possible values are TRUE or FALSE. The value is FALSE if the UPS is
disconnected from the ServerNet II Switch subcomponent.
UPS Type
is the VA rating (volts multiplied by amps) and the firmware version of the UPS
subcomponent of the cluster switch.
UPS ID
is the number used to identify the UPS subcomponent of the cluster switch.
UPS Part Number
is the part number of the UPS subcomponent of the cluster switch.
UPS Poll Interval
is the interval in which the firmware polls the UPS subcomponent of the cluster
switch for status.
LOAD Command
The LOAD command is a sensitive command. It allows you to download a
configuration or firmware file from the server to the ServerNet II Switch subcomponent
of the cluster switch.
The LOAD command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
NEAREST fabric-ID
specifies the cluster switch on the specified (X or Y) external ServerNet fabric.
Note. The LOAD command is intended for service providers only. To load firmware or config-
uration for a cluster switch, use the TSM Service Application.
LOAD [ /OUT file-spec/ ] SWITCH $ZZSMN, NEAREST {fabric-ID },
{ [ FIRMWARE { filename } ] | [ CONFIG { filename }, POSITION
{ position } , TOPOLOGY topology ] }