ServerNet Cluster Manual

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster Manual—520575-002
9-16
PRIMARY Command
PRIMARY Command
The PRIMARY command is a sensitive command. It causes a processor switch, where
the backup processor becomes the primary processor, and the primary processor
becomes the backup processor. PRIMARY is a sensitive command.
The PRIMARY command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
cpunum
is the processor number of the current backup processor for the ServerNet SAN
manager process.
Consideration
Wild cards are not supported for the PRIMARY PROCESS command.
Example
The following command causes the previously configured backup processor for the
ServerNet SAN manager process (processor 3) to become the primary processor.
> PRIMARY PROCESS $ZZSMN, 3
RESET Command
The RESET command is a sensitive command. It allows you to perform a hard or soft
reset of the ServerNet II Switch. (The ServerNet II Switch is the principal
subcomponent of the cluster switch.)
The RESET command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
PRIMARY [ /OUT file-spec/ ] PROCESS $ZZSMN [, cpunum ]
RESET [ /OUT file-spec/ ] SWITCH $ZZSMN,
[ NEAREST { fabric-ID }], [ HARD | SOFT ]