ServerNet Cluster Manual

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster Manual—520575-002
9-17
Considerations
NEAREST
allows you to designate the ServerNet II Switch to which the firmware or
configuration is downloaded by specifying the cluster switch that is directly
connected to the server.
fabric-ID
specifies the cluster switch on the specified (X or Y) external ServerNet fabric.
HARD | SOFT
allows you to designate the type of reset.
Considerations
•
The RESET command is a sensitive command and can be used only by a super-
group user (255, n) ID.
•
Wild cards are not supported for the RESET command.
RESET SWITCH Command Examples
The following example performs a soft reset of the ServerNet II Switch subcomponent
of the nearest X-fabric cluster switch:
> RESET SWITCH $ZZSMN, NEAREST X, SOFT
This command should only be issued by Compaq trained support personnel.
Executing this command will force the switch into a soft reset. A soft
reset restarts the switch firmware, but does not interfere with ServerNet
pass-through data traffic via the switch. When executing this command,
be sure that cabling changes on any links directly connected to the switch
are not performed.
Do you wish to continue with this command? (Y / [N]) Y
The nearest ServerNet switch in the external ServerNet Y fabric has been soft
reset.
Hard Reset Reinitializes the router-2 ASIC within the ServerNet II
Switch, disrupting the routing of ServerNet packets through
the switch for about 12 seconds.
Soft Reset Restarts the firmware on the ServerNet II Switch but does
not interfere with ServerNet pass-through data traffic.