ServerNet Cluster Manual

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster Manual—520575-002
9-19
Considerations
Considerations
•
The STATUS command displays connection or cluster switch information for both
external ServerNet fabrics unless the ONLY option is specified.
•
In addition to the values described in the STATUS command displays, you might
see values of N/A or UNKNOWN. In general, a value of N/A means that a value is
not applicable or not expected for the field. A value of UKNOWN means that a
value is expected, but cannot be obtained for some reason.
STATUS CONNECTION Command Example
The following example shows the STATUS CONNECTION $ZZSMN command:
> SCF STATUS CONN $ZZSMN
| STATUS CONNECTION X Fabric Y Fabric
|---------------------------------------------------------------------------|
| Command Status | OK | OK |
| Status Detail | No Status Detail | No Status Detail |
|---------------------------------------------------------------------------|
| Fabric Access | No Error | No Error |
|--------------------|---------------------------|--------------------------|
| Status Result | MSEB Port | Switch Port | MSEB Port | Switch Port|
|--------------------|-------------|-------------|-------------|------------|
| Port Status Valid | TRUE | TRUE | TRUE | TRUE |
| Port Status | LINK ALIVE | LINK ALIVE | LINK ALIVE | LINK ALIVE |
| Link Speed | 125 MB/S | 125 MB/S | 125 MB/S | 125 MB/S |
| Link Lvl Prtcl Rcv | ENABLED | ENABLED | ENABLED | ENABLED |
| Link Lvl Prtcl Trn | ENABLED | ENABLED | ENABLED | ENABLED |
| Pckt Lvl Prtcl Rcv | ENABLED | ENABLED | ENABLED | ENABLED |
| Pckt Lvl Prtcl Trn | ENABLED | ENABLED | ENABLED | ENABLED |
| Lost Optical Signl | ENABLED | FALSE | ENABLED | FALSE |
| Status For Neighbr | N/A | OK | N/A | OK |
| Target Output Port | ENABLED | ENABLED | ENABLED | ENABLED |
| Node Number Mask | 0x000fc000 | 0x000fc000 | 0x000fc000 | 0x000fc000 |
| Node Routing ID | 0x000d8000 | 0x000d8000 | 0x000d8000 | 0x000d8000 |
| SvNet Node Number | 2 | 2 | 2 | 2 |
| NNA Prog State | ENABLED | N/A | ENABLED | N/A |
|--------------------|-------------|-------------|-------------|------------|
Total Errors = 0 Total Warnings = 0
In this example:
Command Status
is the general condition of the connection. For a list of possible values, see
Command Status Enumeration on page 9-37.
Status Detail
is the specific condition of the connection. For a list of possible values, see Status
Detail Enumeration on page 9-37