ServerNet Cluster Manual

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster Manual—520575-002
9-25
STATUS SWITCH Command Example
STATUS SWITCH Command Example
The following example shows the STATUS SWITCH $ZZSMN command:
> SCF STATUS SWITCH $ZZSMN
STATUS SWITCH X Fabric Y Fabric
|---------------------------------------------------------------------------|
|Command Status | OK | OK |
|Status Detail | No Status Detail | No Status Detail |
|-------------------|---------------------------|---------------------------|
|General Status | ServerNet Switch | ServerNet Switch |
|-------------------|---------------------------|---------------------------|
|FW/HW Status Valid | TRUE | TRUE |
|At Least One Error | FALSE | FALSE |
|Unknown Error | No Error Detected | No Error Detected |
|Switch Response | PASSED | PASSED |
|Switch Ownership | No Owner | No Owner |
|Owner ID | N/A | N/A |
|-------------------|---------------------------|---------------------------|
|Firmware Status | ServerNet Switch | ServerNet Switch |
|-------------------|---------------------------|---------------------------|
|Program Checksum | Status OK | Status OK |
|Dflt Config Loaded | FALSE | FALSE |
|New Conf Aftr Load | Status OK | Status OK |
|Bth Cnfs Aftr Load | Status OK | Status OK |
|SP Ran Ov Allc Sp | FALSE | FALSE |
|Program CRC | Status OK | Status OK |
|Router Config CRC | Status OK | Status OK |
|Firmware Images | Images The Same | Images The Same |
|Config Images | Images The Same | Images The Same |
|-------------------|---------------------------|---------------------------|
|Hardware Status | ServerNet Switch | ServerNet Switch |
|-------------------|---------------------------|---------------------------|
|SRAM Memory Test | PASSED | PASSED |
|Flash Sector Test | PASSED | PASSED |
|SEEPROM Checksum | Status OK | Status OK |
|SBUSY Error | No Error Detected | No Error Detected |
|FLASH Program Err | No Error Detected | No Error Detected |
|Power Supply Fan | Status OK | Status OK |
|Router Self Check | FALSE | FALSE |
|Flash ID String | Status OK | Status OK |
|Flash Boot Lckot 0 | No Error Detected | No Error Detected |
|Flash Boot Lckot 1 | No Error Detected | No Error Detected |
|-------------------|---------------------------|---------------------------|
|UPS Status | UPS | UPS |
|-------------------|---------------------------|---------------------------|
|Cable Detected | TRUE | TRUE |
|UPS Response | PASSED | PASSED |
|UPS On Ok Status | NORMAL | NORMAL |
|Mode Of Operation | Line Operation | Line Operation |
|Battery Voltage | Status OK | Status OK |
|Battery Management | FLOATING | RESTING |
|Line Regulation | Step Down (Buck) | Step Down (Buck) |
|Attention Required | NONE | NONE |
|Immediate Attn Req | NONE | NONE |
|Backup Time | 44 minutes or more | 44 minutes or more |
|Nominal Input Volt | 0120.70 | 0120.60 |
|-------------------|---------------------------|---------------------------|
|AC Power Status | AC Transfer Switch | AC Transfer Switch |
|-------------------|---------------------------|---------------------------|