ServerNet Cluster Manual

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster Manual—520575-002
9-27
STATUS SWITCH Command Example
Unknown Error
indicates whether an error of unknown type (hardware or firmware) occurred.
Possible values are Error Detected or No Error Detected.
Switch Response
indicates the success of cluster switch response test. Possible values are
PASSED or FAILED.
Switch Ownership
indicates whether there is an owner for the cluster switch. Ownership is required
for some sensitive commands. Possible values are Owned, No Owner, and
Locally Owned.
Owner ID
indicates the ID of the cluster switch owner if there is an owner. Otherwise the
value is N/A (not applicable).
Program Checksum
indicates the status of the program checksum. Possible values are Status OK
and Status Bad.
Dflt Config Loaded
indicates whether the factory default router configuration is loaded. Possible
values are TRUE or FALSE.
New Conf Aftr Load
indicates the status of a new configuration after a load. Possible values are
Status OK and Status Bad. If the status is bad, the previous configuration is
used.
Bth Cnfs Aftr Load
indicates the status of both configurations stored in the ServerNet II Switch
memory after a load. Possible values are Status OK and Status Bad. If the
status is bad, the previous configuration is used.
SP Ran Ov Allc Sp
indicates whether the service processor ran over the allocated space. Possible
values are TRUE or FALSE.
Program CRC
indicates the status of the program cyclic redundancy check (CRC). Possible
values are Status OK and Status Bad.