ServerNet Cluster Manual

SCF Error Messages
ServerNet Cluster Manual—520575-003
10-5
ServerNet Cluster (SCL) Error Messages
SCL Error 00009
Cause. A processor switch was not performed. The process pair continues to execute
in the current processor(s).
Effect. The command is not executed. SCF waits for the next command.
Recovery. Verify the processors used by the ServerNet cluster monitor process. Retry
the command if necessary.
SCL Error 00010
Cause. The MSGMON process does not exist. The probable cause is that the
processor hosting the MSGMON process is not running.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Make sure the processor hosting the MSGMON process is loaded. Then
reissue the command.
SCL Error 00011
Cause. The ServerNet cluster subsystem failed to initiate START processing.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Make sure ServerNet cables are connected from the node to the ServerNet
II Switch. The subsystem cannot be started until the cables are connected and the
external system area network (SAN) manager process (SANMAN) has communicated
with the ServerNet II Switch. Check the event logs for error messages. Once any
problems have been resolved, reissue the command.
SCL Error 00012
Cause. The subsystem failed to initiate shutdown processing.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Check the event logs for error messages. Once any problems have been
resolved, reissue the command.
SCL E00009 Processor switch failed.
SCL E00010 MsgMon process does not exist.
SCL E00011 Subsystem start failure.
SCL E00012 Subsystem shutdown failure.