ServerNet Cluster Manual

SCF Error Messages
ServerNet Cluster Manual—520575-003
10-9
SANMAN (SMN) Error Messages
SMN Error 00008
Cause. An unexpected error was returned from the external ServerNet SAN manager
process ($ZZSMN) during the processing of a command.
This error is often preceded by one or two lines of additional text providing more
specific information about the error. For example:
***ERROR: Invalid Parameter
***ERROR DETAIL: Bad Fabric ID Setting
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct the cause of the error and then reissue the command.
SMN Error 00009
Cause. The reset type attribute values SOFT and HARD were both specified in a
single command.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command using only one reset type attribute value (SOFT or
HARD).
SMN Error 00010
Cause. A reset type attribute value (SOFT or HARD) was not specified.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command and specify a reset type attribute value (SOFT or
HARD).
SMN Error 00011
Cause. A NEAREST switch fabric attribute value (X or Y) was not specified.
Effect. The command is not executed. SCF waits for the next command.
SMN E00008 Error returned from the external ServerNet SAN
manager.
SMN E00009 Only one reset type attribute value (SOFT or HARD)
is allowed.
SMN E00010 A reset type attribute value (SOFT or HARD) is
required.
SMN E00011 A NEAREST switch fabric attribute value (X or Y)
is required.