ServerNet Cluster Manual

SCF Error Messages
ServerNet Cluster Manual—520575-003
10-10
SANMAN (SMN) Error Messages
Recovery. Reissue the command and specify a NEAREST switch fabric attribute
value (X or Y).
SMN Error 00012
Cause. A sensitive command was executed noninteractively (for example, using an
OBEY file).
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command from an interactive SCF session.
SMN Error 00013
Cause. More than one attribute was specified in a single ALTER command.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command with only one attribute (FABRIC, LOCATOR, or
BLINK).
SMN Error 00014
Cause. An attribute (FABRIC, LOCATOR, or BLINK) was not specified in an ALTER
command.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command and specify an attribute (FABRIC, LOCATOR, or
BLINK) to ALTER.
SMN Error 00015
Cause. Both load file attributes (FIRMWARE and CONFIG) were specified in a LOAD
command.
Effect. The command is not executed. SCF waits for the next command.
SMN E00012 The command can only be executed interactively.
SMN E00013 Only a single attribute can be specified for each
ALTER command.
SMN E00014 An attribute (FABRIC, LOCATOR, or BLINK) to ALTER
is required.
SMN E00015 Specifying both FIRMWARE and CONFIG attributes is
not allowed.