ServerNet Cluster Manual

SCF Error Messages
ServerNet Cluster Manual—520575-003
10-12
If You Have to Call Your Service Provider
SMN Error 00020
Cause. The specified POSITION attribute is not compatible with the specified
TOPOLOGY attribute.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command and specify POSITION and TOPOLOGY attributes
that are compatible. For example, a position of 3 is only allowed with a 24-node
(24NODES) topology.
SMN Error 00021
Cause. A CONFIG attribute was specified without a TOPOLOGY attribute to identify
the topology of the cluster.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command and specify a TOPOLOGY attribute.
If You Have to Call Your Service Provider
If the recovery for an error message indicates you should contact your service provider,
be prepared to supply the following information. (If the error caused SCF to terminate,
reenter SCF.)
1. Enter a LOG command to collect the following displays into a single file. For
example:
-> LOG PROBLEM !
2. Enter a LISTPM command to collect information about the product versions of the
SCF components, a list of the product modules on your system, and information
about any product modules running when the error occurred. For example:
-> LISTPM
3. Enter an ENV command to collect information about the SCF environment that was
present when the error occurred. For example:
-> ENV
If the error caused SCF to terminate, respecify any environmental characteristics
that were present when the error occurred.
SMN E00020 The specified POSITION and TOPOLOGY attributes
are not compatible.
SMN E00021 The CONFIG attribute requires a TOPOLOGY
attribute.