ServerNet Cluster Manual

SCF Changes at G06.21

ServerNet Cluster Manual—520575-003

I-2

Using SCF Commands for SANMAN

This section describes the changes made to SCF commands for the SNETMON

product module. The changes are backward compatible and still support the star

topologies and the 6770 switch. The 6780 switch is also supported, but the syntax for

specifying each type of switch is different. Also, the output of the commands differs

depending on the switch type.

For more details, consult the SCF help text for this product module. To access SCF

help for SANMAN, at the SCF prompt, type:

> HELP SMN

ALTER SWITCH

The syntax for this command has changed. The FABRIC specifier does not change the

setting of the 6770 switch, but designates which switch to alter. To configure a 6770

switch for use on a particular fabric, use the new FABRICSETTING attribute. For

details, see the SCF help.

STATUS CONN

None of the changes to this command affect clusters with the star topologies, but the

syntax presented earlier in this manual is incorrect when using this product version or

later. For the correct syntax, see the SCF help.

STATUS SWITCH

None of the changes to this command affect clusters with the star topologies, however

the syntax presented earlier in this manual is incorrect when using this product version

or later. For the correct syntax, see the SCF help.

New SCF Error Messages for SANMAN

Because the syntax is different for 6770 and 6780 switches, many new error messages

have been added in case you use incorrect syntax for your type of switch. For a

complete listing of SCF error messages for SANMAN, see the ServerNet Cluster 6780

Operations Guide.