ServerNet/FX Adapter Configuration and Management Manual

ServerNet/FX Adapter Subsystem SCF Commands
ServerNet/FX Adapter Configuration and Management Manual—426872-002
4-26
INFO LBU Command
The following example is similar to the display returned by the INFO LBU command
with the DETAIL option:
The following descriptions explain the fields returned by the previous two INFO
commands for the LBU object:
System Number
identifies the system number of the node on which the ServerNet/FX adapter is
located.
Cluster Number
identifies the cluster number currently being used by the ServerNet/FX adapter.
Controller Type
identifies the type of controller. FX2SA identifies the controller as a ServerNet/FX 2
adapter. FXSA identifies the controller as a ServerNet/FX adapter.
Power Right
identifies the power level for the link to the right cluster. A value of 0 specifies a low
power level and is used for distances up to 2 Km. A value of 1 specifies a high
power level and is used for distances from 2 Km to 4 Km.
Location
identifies the group, module, and slot where the ServerNet/FX adapter specified by
this LBU is physically located.
Startstate
identifies the start mode of the ServerNet/FX adapter. A value of STARTED
specifies that the ServerNet/FX adapter will be started automatically when the
system is loaded. STOPPED specifies that the ServerNet/FX adapter will not be
started automatically when the system is loaded, and must be manually started
using the ServerNet/FX adapter subsystem SCF START LBU command.
SCF> INFO LBU $ZZFOX.#X, DETAIL
FOX Detailed Info LBU \GATE3.$ZZFOX.#X At 08 May 2001, 16:49:05.606
System Number..... 56 *Sample Interval.. 1:00:00.000
Cluster Number.... 1 Poll Interval..... 0.30 second
Controller Type... FX2SA Power Left........ 0
Power Right....... 0 Prod ID........... T6742
Location.......... 1 ,1 ,53
Startstate........ STARTED
Last Used Download Program File:$SYSTEM.SYS20.M6742
Module:STANDARD
*Program File for Next Download:$SYSTEM.SYSTEM.M6742
*Module:STANDARD