ServerNet/FX Adapter Configuration and Management Manual

ServerNet/FX Adapter Subsystem SCF Commands
ServerNet/FX Adapter Configuration and Management Manual—426872-002
4-33
START PATH Command
Examples
The following command starts the FOX direct logical path XR from processor 10 in the
local cluster to processor 3 in \GATE5:
SCF> START PATH $ZZFOX.10, TO \GATE5.3, SUB XR
The output from the above START PATH command shows that the XR FOX direct
logical path from processor 10 on \GATE3 to processor 3 on \GATE5 was successfully
started.
The following command starts all the FOX direct logical paths from processor 12 in the
local cluster to processor 0 in \GATE7:
SCF> START PATH $ZZFOX.12, TO \GATE7.0
SCF> START PATH $ZZFOX.10, TO \GATE5.3, SUB XR
FOX Detailed Status PATH \GATE3.$ZZFOX.10, TO \GATE5.3
At 11 May 2001, 15:40:05.327
Local Cluster
-------------
Cluster Number... 3 XLBU Logical State.... STARTED
System Name...... \GATE3 YLBU Logical State.... STARTED
System Number.... 60 TOS Version........... Q06
Remote Cluster(s)
-----------------
Cluster System System TOS CPUs Path CPU
Number Name Number Version UP Down Stuck
------- ------ ------ ------- ---- ---- -----
5 \GATE5 54 Q06 16 0 0
Processor-to-Processor Connectivity Matrix from \GATE3.10 to \GATE5.3
TO 3
X Y
FROM L R L R
10 . . . .