ServerNet/FX Adapter Configuration and Management Manual

ServerNet/FX Adapter Subsystem SCF Commands
ServerNet/FX Adapter Configuration and Management Manual—426872-002
4-42
STATUS SUBNET Command
The following descriptions explain the fields returned by the STATUS command for the
SUBNET object:
Name
identifies the name of the FOX monitor process, which must be $ZZFOX.
State
identifies the summary state of the SUBNET object, which must be STARTED.
System#
identifies the system number of the node on which the ServerNet/FX adapter is
located.
Cluster#
identifies the cluster number currently being used by the ServerNet/FX adapter.
The following example is similar to the display returned by the STATUS SUBNET,
DETAIL command. The example shows the view of a 5-cluster FOX ring. The display
lists the trail of clusters on the FOX ring in both the left and right directions on
$ZZFOX.#X and $ZZFOX.#Y:
The following descriptions explain the fields returned by the STATUS SUBNET, DETAIL
command:
Summary State
identifies the summary state of the SUBNET object, which must be STARTED.
SCF> STATUS SUBNET $ZZFOX, DETAIL
FOX Detailed Status SUBNET \GATE3.$ZZFOX At 08 May 2001, 17:50:23.310
Summary State..... STARTED Cluster Number.... 5
System Number..... 54
Known Active Clusters In The Ring
---------------------------------
Cluster Name System Number LH-Ldev Remote LH Status
------- ---- ------------- ------- ----------------
1 \PRUNE 175 $29 Up
3 \FOXII 147 $24 Up
8 \FORTY 106 $34 Up
10 \SVLDEV 77 $35 Up
View Ring Topology Ring Termination Status
---- ------------- -----------------------
X Left 1 8 3 10 Ring Continuous
Y Left 1 8 3 10 Ring Continuous
X Right 10 3 8 1 Ring Continuous
Y Right 10 3 8 1 Ring Continuous