ServerNet/FX Adapter Configuration and Management Manual

ServerNet/FX Adapter Configuration and Management Manual—426872-002
B-1
B Error Messages
This appendix lists and explains the error messages returned by the FOX SCF
command interpreter.
FOX SCF Command Error Messages
The following error messages can be returned by the FOX SCF command interpreter.
Each message has a Cause, an Effect, and a Recovery explanation.
FOX E00001
Cause. The LBU ($ZZFOX.#X or $ZZFOX.#Y) associated with the ServerNet/FX
adapter is already connected in the direction specified.
Effect. The CONNECT command failed.
Recovery. This is a warning. Make sure you specified the proper direction (left or
right); if not, reissue the command.
FOX E00003
Cause. The LBU ($ZZFOX.#X or $ZZFOX.#Y) associated with the ServerNet/FX
adapter is already disconnected in the direction specified.
Effect. The DISCONNECT command failed.
Recovery. This is a warning. Make sure you specified the proper direction (left or
right); if not, reissue the command.
FOX E00005
Cause. The backup processor is down.
Effect. The PRIMARY command, issued to switch the FOX monitor process
($ZZFOX) to the backup processor, failed.
Recovery. Reload the processor and reissue the command.
LBU is already connected in that direction.
LBU is already disconnected in that direction.
The CPU specified is not up and therefore cannot be switched
to.