ServerNet/FX Adapter Configuration and Management Manual

Error Messages
ServerNet/FX Adapter Configuration and Management Manual—426872-002
B-6
FOX SCF Command Error Messages
FOX E00105
Cause. An invalid name was given for the ServerNet/FX adapter. The ServerNet/FX
adapter can have only one of two names: $ZZFOX.#X or $ZZFOX.#Y.
Effect. The command failed.
Recovery. Use $ZZFOX.#X for a ServerNet/FX adapter connected to the X-fabric (slot
51 or 53) or $ZZFOX.#Y for a ServerNet/FX adapter connected to the Y-fabric (slot 52
or 54), and reissue the command.
FOX E00106
Cause. The processor specified in the PRIMARY command is already the primary
processor for the FOX monitor process ($ZZFOX).
Effect. The PRIMARY command failed.
Recovery. This is a warning. Make sure that you specified the correct processor as
the primary. If not, reissue the command using the correct processor.
FOX E00107
Cause. The FOX monitor process ($ZZFOX) is not configured to run on the specified
processor.
Effect. The PRIMARY command failed.
Recovery. Check the processor number of the backup processor using the INFO
command. Reissue the PRIMARY command using the correct backup processor.
FOX E00108
Cause. The specified token has an invalid value. Enter HELP FOX command at the
SCF prompt to get the command syntax and the list of valid token values.
Effect. The command failed.
Recovery. Reissue the command with a valid token value.
Invalid LBU name. Please specify $ZZFOX.#X or $ZZFOX.#Y.
The specified CPU is already the primary.
The CPU specified is not configured.
Invalid value for token-name.