ServerNet/FX Adapter Configuration and Management Manual

Managing the ServerNet/FX Adapter Subsystem
ServerNet/FX Adapter Configuration and Management Manual—426872-002
3-15
Adding a Cluster to a FOX Ring
If the left cable neighbor is running the D-series NonStop Kernel operating system,
enter the following SCF commands:
SCF> DISCONNECT LBU $IPB.#Y, RIGHT
SCF> DISCONNECT LBU $IPB.#X, RIGHT
If the left cable neighbor is running the G-series NonStop Kernel operating system,
enter the following SCF commands:
SCF> DISCONNECT LBU $ZZFOX.#Y, RIGHT
SCF> DISCONNECT LBU $ZZFOX.#X, RIGHT
At the right cable neighbor:
If the right cable neighbor is running the D-series NonStop Kernel operating
system, enter the following SCF commands:
SCF> DISCONNECT LBU $IPB.#Y, LEFT
SCF> DISCONNECT LBU $IPB.#X, LEFT
If the right cable neighbor is running the G-series NonStop Kernel operating
system, enter the following SCF commands:
SCF> DISCONNECT LBU $ZZFOX.#Y, LEFT
SCF> DISCONNECT LBU $ZZFOX.#X, LEFT
D-series NonStop Kernel operating system FOX subsystem SCF commands are
explained in the SCF Reference Manual for FOX.
Task 2: Verify the links have been logically disconnected
Verify that the left and right cable neighbors have been logically disconnected.
When verifying on a NonStop K-series system running the D-series NonStop
Kernel operating system, enter the following SCF command:
SCF> STATUS SUBNET $IPB, DETAIL
When verifying on NonStop S-series system running the G-series NonStop Kernel
operating system, enter the following SCF command:
SCF> STATUS SUBNET $ZZFOX, DETAIL
The ring status is displayed in the Ring Termination Status field. A value of
Disconnected by Operator indicates that the ring has been logically disconnected.
Other possible values for the Ring Termination Status field are explained in Section 4,
ServerNet/FX Adapter Subsystem SCF Commands.