ServerNet/FX Adapter Configuration and Management Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Overview of the ServerNet/FX Adapter Subsystem
- 2 Configuring the ServerNet/FX Adapter Subsystem
- 3 Managing the ServerNet/FX Adapter Subsystem
- 4 ServerNet/FX Adapter Subsystem SCF Commands
- 5 Troubleshooting
- A SCF Command Summary
- B Error Messages
- C ServerNet/FX Adapter Self-test Codes
- Glossary
- Index
ServerNet/FX Adapter Subsystem SCF Commands
ServerNet/FX Adapter Configuration and Management Manual—426872-002
4-22
Example
•
After you issue the DISCONNECT command on a particular adapter, a few
seconds may pass on the FOX ring before all clusters notice that the adapter is
unusable in the specified direction.
•
The DISCONNECT command fails unless the ServerNet/FX adapter is in the
STARTED summary state.
Example
To fully disconnect a FOX cluster before stopping the cluster (using the STOP
command), issue the following four commands:
SCF> DISCONNECT LBU $ZZFOX.#X, RIGHT
SCF> DISCONNECT LBU $ZZFOX.#X, LEFT
SCF> DISCONNECT LBU $ZZFOX.#Y, RIGHT
SCF> DISCONNECT LBU $ZZFOX.#Y, LEFT