SL500 (M852x) Tape Library Installation and User's Guide (G06.31+, H06.11+, J06.03+)

Configuring the M8706A Tape Drive for the NonStop

BladeSystem Server

SL500 (M852x) Tape Library Installation and User’s Guide—541531-010

B-3

Troubleshoot the Tape Configuration

Check that the processes on the CLIM are running and if they are not, start them.

If either of these conditions occur:

The SCF STATUS CLIM $ZZCIP.* command shows that the CLIM object is still

in the STARTING state after a few minutes, or

The SCF STATUS TAPE command shows that the tape drive is still in the

STARTING state after a few minutes

The OSM Service Connection indicates that the resource needs attention

Check for event messages in the Event Message Service (EMS) log. Use the OSM

Event Viewer to view the EMS log.

Refer to the Operator Messages Manual for cause, effect, and recovery

information for event messages.