SNAX Connection Manager (SNAX/CM) Manual

40: ZSXC-EVT-OPERATION-TIMED-OUT
SNAX/CM Event Messages
A–60 097842 Tandem Computers Incorporated
ZSXC-TKN-CM-TIMEOUT-TYPE
reports the type of connection manager operation expected:
0 Unknown
1 Allow call-in
2 Call out
3 Accept call after call validation
4 Accept call after XID validation
5 Call disconnect
6 Wait for connection after call out
7 Wait for connection after call validation
8 Wait for connection after XID validation
9 Wait for disconnect after call disconnect
10 Wait for XID after call validation
Conditional Tokens
ZCOM-TKN-SUBJ-SU
is an optional token that contains the name of the subdevice for which this event
occurred.
Cause. There is a problem in SNAX/XF, X25AM, TLAM, or the network. If a timeout
occurs for an enabled line, SNAX/CM issues a disconnect request; call-in is enabled
after a 1-minute delay.
Effect. For lines that are not enabled, the port is disconnected, and no retry is
attempted. A connection management procedure failed to return an expected
completion or status within the 1-minute timeout period allowed. (The 1-minute timer
is internal to the SXCMGR process and cannot be controlled by the user.)
Recovery. Gather the following information as appropriate and contact your Tandem
representative:
SNAX/XF SYSGEN and SCF configuration files
X25AM or TLAM SYSGEN and SCF configuration files
SXCMGR SAVE ABEND file
Trace files from SNAX/CM, $SSCP, X25AM or TLAM, and line handler process
Event and log files
SNAX/CM command (OBEY) file, if any.