SNAX Connection Manager (SNAX/CM) Manual

Text Messages
SNAX/CM Messages
B–6 097842 Tandem Computers Incorporated
Table B-2. Return Codes for SNAX/CM (Page 5 of 5)
Range Reason for Return Code Return Code Code
1024 to
2047
(continued)
RC_CONNECT_IN_PROGRESS
RC_LINE_CONNECTED
RC_LINE_ENABLED
RC_LINE_NOT_ENABLED
RC_CALLIN_IN_PROGRESS
RC_CALLIN_CONNECTED
RC_DISA_IN_PROGRESS
RC_OPEN_VALCALL_PROC_FAIL
RC_OPEN_VALXID_PROC_FAIL
RC_WRITE_VALCALL_PROC_FAIL
1040
1041
1042
1043
1044
1045
1046
1047
1048
1049
RC_WRITE_VALXID_PROC_FAIL
RC_CALL_VALIDATION_TIMEOUT
RC_CALL_VALIDATION_FAIL
RC_CALL_VALIDATION_BAD_RESP
RC_XID_VALIDATION_TIMEOUT
1050
1051
1052
1053
1054
RC_XID_VALIDATION_FAIL
RC_XID_VALIDATION_BAD_RESP
RC_DISCONNECT_FAIL_TIMEOUT
RC_SXCM_TIMEOUT
RC_FILE_SYSTEM_ERROR
1055
1056
1057
1058
1059
RC_LOG_NOT_ACTIVE
RC_INVALID_FILE_CODE
RC_TRACE_SEG_ALLOC_ERROR
RC_TRACE_SEG_UNAVAILABLE
RC_TRACE_ALREADY_STARTED
RC_COMMAND_INVALID
RC_PORT_NAME_NOT_ALLOWED
1060
1061
1062
1063
1064
1065
1066
Text Messages SNAX/CM processes commands and writes the results in either an OUT file or a LOG
file. Because most of the activities are performed in nowait mode, SNAX/CM writes
the results up to the point at which the commands have been sent to the SNAX/XF
service manager.
Square brackets indicate that the parameters enclosed may or may not be displayed in
the message, depending on the configuration.
Messages in the OUT File Messages in the OUT file are grouped either as syntax errors or as status messages
related to the results of initiating a command. Check the LOG file for messages sent
back by the SNAX/XF service manager.