SNAX Connection Manager (SNAX/CM) Manual

Text Messages
SNAX/CM Messages
097842 Tandem Computers Incorporated B–23
time-date LOG (#33):
LINE line-name [,PORT port-name ],
WRITE PROCESS process-name FAILED, FE = fe-error
Cause. After the line is connected, SNAX/CM opens process-name specified by
either the ENABLE or the CONNECT command, but fails to write the interface
messages to process-name .
Effect. SNAX/CM leaves the connection active and logs this message.
Recovery. Check the file-system error number to determine the reason for the
command not being accepted.
time-date LOG (#34):
UNABLE to ACCESS APPL mgr .# appl ,
RC = rc-code , FE = fe-error
Cause. SNAX/CM is unable to access SNAX/XF.
Effect. If the error is recoverable, SNAX/CM tries the failing connection management
operation again; otherwise, SNAX/CM logs this message and issues an ABEND
command. Save both the abend file and the log file, and contact your Tandem
representative.
Recovery. Check the return code and file-system error number to determine the reason
for the command not being accepted.
time-date LOG (#35):
LINE line-name [,PORT port-name ],
DISABLE COMMAND COMPLETED
Cause. The line is disabled.
Effect. The DISABLE command is processed.
Recovery. Informational message only; no corrective action is needed.