SNAX Connection Manager (SNAX/CM) Manual

Text Messages
SNAX/CM Messages
097842 Tandem Computers Incorporated B–25
time-date LOG (#39):
LINE line-name [,PORT port-name ],
DISABLED, UNABLE TO NOTIFY SNAX/XF,
RC = rc-code , FE = fe-error
Cause. The line is disabled.
Effect. When SNAX/CM attempted to disconnect from SNAX/XF, the request failed.
Recovery. Check the return code and file-system error number to determine the reason
for the command not being accepted.
time-date LOG (#40):
LINE line-name[ ,PORT port-name ], operation TIMED OUT
Cause. There is a problem in SNAX/XF or in the network, where operation is one of
the following:
Allow call-in
Call-out
Call accept after call validate
Call accept after XID validate
Call disconnect
Connect status after call-out
Connect status after call validate
Connect status after XID validate
Disconnect status after call disconnect
XID validate status after call validate
Effect. A SNAX/CM procedure failed to return an expected completion or status
within the 1-minute timeout period allowed. If a timeout occurs for an enabled line, a
disconnection is attempted and call-in is enabled after a 1-minute delay. For lines that
are not enabled, no retry is attempted. (Note that the 1-minute timer is internal to
SXCMGR and cannot be controlled by the user.)
Recovery. Retry the command, depending on the operation desired.