SNAX Connection Manager (SNAX/CM) Manual

EXIT Command
SNAX/CM Commands
3–18 097842 Tandem Computers Incorporated
EXIT Command The SNAX/CM EXIT command is used to terminate SNAX/CM operations. The
syntax of the EXIT command is as follows:
EX[IT]
Nothing is returned when the EXIT command is issued.
Using the EXIT Command
To ensure continuous operation, SXCMGR must continue to run. If you stop SXCMGR
using the EXIT command, lines that were enabled accept one more call-in request, then
will accept no more. To avoid this situation, simply issue a DISABLE command
followed by a DISCONNECT command prior to exiting the SXCMGR run. You can
also issue a DISCONNECT command prior to issuing an ENABLE command the
second time you run SXCMGR.