SNAX Connection Manager (SNAX/CM) Manual

HELP Command
SNAX/CM Commands
097842 Tandem Computers Incorporated 3–19
HELP Command The SNAX/CM HELP command is used only in interactive mode to provide
information about SNAX/CM commands. Note that the application program cannot
issue a WRITEREAD request using the SNAX/CM HELP command; it will be rejected
with the return code, RC_COMMAND_INVALID. The syntax of the HELP command
is as follows:
H[ELP] [ command | ALL]
where command can be one of the command names described below:
APPL[NAME]
C[ONNECT]
DISA[BLE]
DISC[ONNECT]
EMS[COLLECTOR]
ENA[BLE]
EX[IT]
L[OG]
O[BEY]
S[TATUS]
S[TATUS]
TR[ACE]
EX[IT]
Using the HELP Command
The following example shows how the HELP command is used:
-> H ENA (HELP ENABLE)
The returned information is displayed as follows:
ENA[BLE] LINE line-name
[, PORT port-name ]
[, PROCESS { process-name | ( TACL , TACL-name ) }]
[, VALXID process-name ]
[, VALCALL process-name ]
[, TIMEOUT time-out ]