SNAX Connection Manager (SNAX/CM) Manual

LOG Command
SNAX/CM Commands
097842 Tandem Computers Incorporated 3–21
Using the LOG Command
The following example shows how to use the LOG command, and presents
information contained in the sample log file.
Assume the following SNAX/CM commands are issued:
LOG LOG2
TRACE TO TRMGR
APPL #CMAPPL,PW "ABCDEFGH"
ENA LINE $SOXP1, PROCESS $TSV, VALXID $TSV, VALCALL $TSV
The log file CMLOG1 displays the following information when a call-in is completed
successfully and later disconnected:
07/21/1992 09:21:00.11 LOG (#3):
LOG TO $DATA2.SXCMGR.LOG2
07/21/1992 09:21:15.59 LOG (#5):
>) TRACE TO $DATA2.SXCMGR.TRMGR
07/21/1992 09:21:15.97 LOG (#45):
TRACE STARTED SUCCESSFULLY
07/21/1992 09:21:25.79 LOG (#5):
>) APPL #CMAPPL,PW "ABCDEFGH"
07/21/1992 09:21:25.88 LOG (#1):
APPL $SSCP.#CMAPPL, APPLNAME COMMAND COMPLETED
07/21/1992 09:21:54.22 LOG (#5):
>) ENA LINE $SOXP1,PROCESS $TSV,VALCALL $TSV,VALXID $TSV
07/21/1992 09:21:54.37 LOG (#6):
LINE $SOXP1, ENABLE COMMAND ACCEPTED
07/21/1992 09:22:02.87 LOG (#21):
LINE $SOXP1, PORT $X25AM1.#SU1, CALL VALIDATE IN PROGRESS,
STATUS: ALLOWING
07/21/1992 09:22:03.07 LOG (#23):
LINE $SOXP1, CALL VALIDATE OK
07/21/1992 09:22:03.21 LOG (#22):
LINE $SOXP1, PORT $X25AM1.#SU1, XID VALIDATE IN PROGRESS,
STATUS: ALLOWING
07/21/1992 09:22:03.36 LOG (#24):
LINE $SOXP1, XID VALIDATE OK
07/21/1992 09:22:03.69 LOG (#25):
LINE $SOXP1, PORT $X25AM1.#SU1, CALL-IN COMPLETED, PU #PU1,
STATUS: CONNECTED, ALIAS LU $SOXP1.#A100121, LU COUNT 2
SNAX/CM sends a WRITEREAD message with the connected message that contains
the alias LU information to the $TSV process.
07/21/1992 13:00.01 LOG (#17):
LINE $SOXP1, PORT SNADEV.$X25AM1.#SU1, MONITOR STATUS,
STATUS: DISCONNECTED, RC = 40, FE = 0
SNAX/CM then sends a WRITEREAD message with the disconnect information to the
$TSV process.