SNAX Connection Manager (SNAX/CM) Manual

STATUS LINE, PU Command
SNAX/CM Commands
097842 Tandem Computers Incorporated 3–33
XIDSTRING: { xidstring | N/A }
is the configured or currently connected xidstring associated with the PU. If no
xidstring is configured for the PU, then the xidstring received from the X.25
network, if any, is displayed when the PU is connected.
ALIASLU: alias-lu-name
If the PU status is “connected,” alias-lu-name is displayed as generated by
SNAX/XF. This name is in the form $ line .# axnnnn1 for the LUs configured
under the connected PU.
ALIASLUCNT: alias-lu-count
if alias-lu-name is returned, displays the number of LUs connected.
return : (OUTFILE)
if received from the IN file, specifies the text message to be returned to the OUT
file. See Appendix B for detailed descriptions of error messages.
return : ($RECEIVE)
if received from the $RECEIVE file, returns a structured buffer defined above. See
Appendix B for detailed descriptions of return codes.
Using the STATUS LINE,PU Command. The following example shows how the SNAX/CM
STATUS LINE, PU command is used. In this example, the STATUS command is used
to ask for the status of a specific line that was previously enabled:
-> STATUS LINE $SNAP1, PU #PU1
The returned information is displayed as follows:
PU STATUS for PUNAME #PU1
Sample Time : 02/29/1992 11:11:11.11
PU TYPE: SWITCHED FLOATING
PUNAME: #PU1
LINE: $SNAP1, PORT $X25AM.#S2
STATUS: CONNECTED
CALLSTRING: 123456789
XIDSTRING: FFFFFFFF
ALIASLU: $SNAP1.#A100321 ALIASLUCNT: 5