SNAX Connection Manager (SNAX/CM) Manual

STATUS PU Command
SNAX/CM Commands
3–34 097842 Tandem Computers Incorporated
STATUS PU Command
The SNAX/CM STATUS PU command locates a switched floating PU, either in the
pool of floating PUs or after the PU is assigned to a line. The STATUS PU command is
requested by specifying the PU name for switched floating PUs.
The syntax for the SNAX/CM STATUS PU command is as follows:
S[TATUS] PU pu-name
return : (OUTFILE)
{ PU STATUS FOR PUNAME: pu-name
SAMPLE TIME: timestamp
PU TYPE: SWITCHED FLOATING
LINE: { line-name | $SSCP }
PORT port-name | N/A }
STATUS: pu-status
CALLSTRING: { callstring | N/A }
XIDSTRING: { xidstring | N/A }
ALIASLU: alias-lu-name ALIASLUCNT: alias-lu-count
| ERROR MESSAGES }
return : ($RECEIVE)
STRUCT PU^Status^Reply;
BEGIN
STRING base[ 0:-1 ];
INT Return^code;
INT Ferror;
INT Status; -- 1 = Unavailable
-- 2 = Disconnected
-- 3 = Disconnecting
-- 4 = Allowing
-- 5 = Calling
-- 6 = Connected
INT PU^type; -- 1 = Switched Floating
STRUCT PUname( VARSTRING );
STRUCT linename( VARSTRING );
STRUCT portname( VARSTRING );
STRUCT callstring( VARSTRING );
STRUCT xidstring( VARSTRING );
STRUCT alias^lu( VARSTRING );
INT alias^lu^count;
STRING data[ 0:-1 ]; -- variable data for VARSTRINGs
END