SNAX Connection Manager (SNAX/CM) Manual

STATUS PU Command
SNAX/CM Commands
097842 Tandem Computers Incorporated 3–35
PUNAME: pu-name
is an array containing the name of the PU.
PU TYPE: SWITCHED FLOATING
displays the PU configured as a switched floating PU
LINE: line-name
is the name of the SNAX/XF LINE object to which the PU is currently assigned, or
SNAX/XF service manager. When $SSCP is displayed, the PU is not assigned to
any LINE. If LINE line-name is optionally specified in the command request,
pu-name is searched for only the LINE identified by line-name . Otherwise, the
switched floating PUs and then all other lines assigned to the APPL object
controlled by the SNAX/CM process are searched.
PORT port-name
is a unique name used by SNAX/CM to identify and access a particular TLAM
I/O process for Token-Ring networks or an X25AM line handler subdevice for
X.25 networks. Up to 254 ports can be configured in a SYSGEN operation;
SNAX/CM controls each port independently and supports the connection of one
switched PU for each port.
PORT x25am-su-name
is the fully qualified name of the X25AM line handler subdevice, which
provides access to an X.25 network for SNAX/XF lines using the QLLC
protocol (for example, $X25AM1.#SU1). x25am-su-name is the alternative
to the ASSOCIATESUBDEV parameter that supplies the X25AM subdevice
name.
PORT $ device. # xxxxxxx
is the name of a TLAM IOP ($ device ), followed by a user-supplied
alphanumeric character string that follows the naming conventions for
subdevices.
STATUS: pu-status
is one of the following:
1 = Not Available
2 = Disconnected
3 = Disconnecting
4 = Allowing
5 = Calling
6 = Connected