SNAX Creator-2 Configuration and Control Manual

SNAX Creator2 Errors
SCF Error Messages for SNAX Creator-2
B–2 117143 SNAX Creator-2 Configuration and Control Manual
SNAX Creator-2 Errors The following errors can be produced by the SNAX Creator-2 SCF product module:
Error 1 SU definition error: explanation
explanation
explains the reason for the failure when an SU attribute was evaluated.
Cause. An error occurred when adding or altering an SU.
Effect. The application fails to be started.
Recovery. Check the configuration command entered (or the configuration file) to
correct the problem attribute definition. Reissue the command, defining the SU only
once.
Error 2 Invalid data received from the Creator-2 process
Cause. The SNAX Creator-2 SCF product module, while decoding a request received
from the SNAX Creator-2 subsystem, could not find expected information; for
example, the object type may be one that is not supported by the SNAX Creator-2
subsystem.
Effect. The current request record is ignored, and processing continues with the next
request record.
Recovery. The process being accessed may not be a SNAX Creator-2 subsystem. If the
cause for this error message cannot be determined, contact your Tandem support
representative.
Error 3 Duplicate keyword
Cause. A keyword was specified more than once.
Effect. The current request is abandoned.
Recovery. Correct the input data and try again.