SNAX Creator-2 Configuration and Control Manual

Subsystem Control Facility
Introduction to SCF for SNAX Creator-2
1–8 117143 SNAX Creator-2 Configuration and Control Manual
Input Sources and Output
Destinations
SCF accepts command input from a terminal or a disk file; it directs output to a disk
file, an application process, a terminal, or a printer. The initial input source and
output destination are determined by the RUN command used to initiate SCF.
At any time during an SCF session, both the source and the destination can be
temporarily changed. For information about how to set the initial input source and
output destination, and how to change them, see the Subsystem Control Facility (SCF)
Reference Manual.
Online Help SCF provides online support when you use the HELP command, which is described
fully in the Subsystem Control Facility (SCF) Reference Manual. If you enter the HELP
command, SCF responds with a menu that guides you through the available help
options. Simply select from the options displayed in the menu for the information you
need.