SNAX Creator-2 Configuration and Control Manual

CONNECTION Object Type
Objects for SNAX Creator-2
117143 SNAX Creator-2 Configuration and Control Manual 3–5
Attributes An APPL object has the following attributes. See Section 5, “Attributes and
Expressions for SNAX Creator-2,” for more information about these attributes.
General Attributes
Attributes Used for
TACL Applications
Attributes Used for
Pathway Applications
Attributes Used for
Server Applications
CPUS BACKUPCPU PATHMON MESSAGE
MAXARGS PRIMARYCPU PRINTER SERVER
METHOD SEGVOL PROCESS
MINARGS PROGRAM
SYSTEM
Commands The following commands can be applied to the APPL object type:
ADD
ALTER
DELETE
INFO
NAMES
STATUS
CONNECTION
Object Type
The CONNECTION object type is nonconfigurable. It represents an active connection
between a SNAX Creator-2 subsystem and an access method SU. When you add an
SU, a CONNECTION object is automatically created subordinate to the SU. When you
stop an SU, the subordinate CONNECTION objects are deleted as soon as pending
work is complete, typically within a few seconds.
Object Name Format A CONNECTION object name has the following format:
\ node1 .$ process1. # subdevice- \ node2. $ crename2
\ node1. $ process1. # subdevice
is the fully-qualified filename of the SU that the SNAX Creator-2 subsystem
opened to initiate the connection. See “SU Object Type” later in this section.
\ node2. $ crename2
is the process name of the SNAX Creator-2 subsystem that initiated the connection
(set when the RUN CREOBJ command was issued).
\ node2
is a node name commencing with a backslash, followed by one alphabetic
character and up to six alphanumeric characters.
It need not be the same node as the SNAX Creator-2 through which the SCF
command is serviced.